When the machines needed 'code' the Solitare card being flipped would hang in the air until the machine was fed. I used to run both machines and play Solitare at the same time on an old 286 computer. ![]() In 2.5D machining there is time between commands as you mill the side of a part (for instance) which gives plenty of time for Terminal to feed the other machine. You could watch it stair step up alternating between machines. When I was using two iterations of it, one for each machine I was worried what might happen if both machines needed 'code' at the same time. You will want do do some simple tricks to make it comfortable to use but it does a smooth job. Waaaay back, I have a copy and how to set it up if your interested. I confess I didn't figure it out in Hyper. Actually it's the old 'TERMINAL' program, Before Hyper terminal. I had to set the machine then go to the computer and start feeding the program. ![]() ![]() What parameters or how do you get it to drip feed? Do you just slow baud rate? Or use software or hardware handshaking?įorgive me for asking, i have never tried DNCI used three wires and Xon Xoff communication. I use it to transfer cnc files by rs-232 serial port. There is some FREE DNC Software and serial cable connections plan., 04:53 PM #14. Many free file transfer programs, such as Windows Terminal and many other DNC software packages just don't have enough 'tweaks' to enable you to send.
0 Comments
Leave a Reply. |